I suspect Lynn you would be better off with a higher pressure cap
and less block restrictions to water flow. By all means install
a thermocouple down near the base of the spark plug to find out
for sure.
Paul Lamar
What kind (brand) style, type, would I want for that. If it dosn't cost too much I can put a set in the new motor. Would it want to be between the plugs just above the leading? I can do anything like that and make video
of the gage for the whole race (about 45 minutes). Tell me what you want to see and I can do it.
Lynn E. Hanover.
Get a catalog from http://www.omega.com for thermocouples.
You will have to drill the small diameter holes while
the rotor housings are off the engine. They go right along side
the leading plug. There is a risk involved in that the rotor housing
may be more prone to cracking in this area. I would try it
with less than new housings to begin with. Are the cracks
that you have seen in the steel liner or just in
the aluminum part of the rotor housing?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org