I suspect Lynn you would be better off with a higher pressure cap
and less block restrictions to water flow. By all means install
a thermocouple down near the base of the spark plug to find out
for sure.
Paul Lamar
What kind (brand) style, type, would I want for that. If it dosn't cost
too much I can put a set in the new motor. Would it want to be between the
plugs just above the leading? I can do anything like that and make video
of the gage for the whole race (about 45 minutes). Tell me what you want
to see and I can do it.
Lynn E. Hanover.
Get a catalog from http://www.omega.com for thermocouples.
You will have to drill the small diameter holes while
the rotor housings are off the engine. They go right along side
the leading plug. There is a risk involved in that the rotor housing
may be more prone to cracking in this area. I would try it
with less than new housings to begin with. Are the cracks
that you have seen in the steel liner or just in
the aluminum part of the rotor housing?
Paul Lamar
Monty Roberts wrote:
If I remember correctly, TC wire is pretty expensive in the quantities that
you have to order it. I have some Type T wire laying around, and I think
some type K. I will have to check if I have some that is in the right temp
range. If I can find it I will send you some. If I were installing it, I
would drill a hole in the housing. Tap the top of the hole for a small pipe
plug (hex head type, or small bolt will work). Drill a hole through the
center of the bolt. Silicone the TC wire through the bolt with enough slack
to be able to place it in the bottom of the hole. Fill the hole with thermal
grease or oil, screw the bolt in, seal with silicone. To make a TC out of
wire, you need a welder, either electric (specialy made for TC welding), or
I prefer a small hydrogen torch since adjustment does not depend on wire
length. Then you will need some way to read the TC. They make meters for
this, or you could make one if you are good with electronics. You will need
to calibrate the TC with an ice bath and a boiling water bath to get good
numbers.
You can just buy a TC and reader already calibrated and ready to go, but
they can be pricey.
Another thing to consider is that you will want to either shield the TC wire
if you make one, or buy a sheilded one. You are trying to measure very small
signals, right next to the HV ignition wires. You may have to use an RC
filter to take out the ignition noise. This should be easy, because it is
much higher frequency than the TC signal.
Monty
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org