Subject: thermostats and racing pressure caps
From: ACRE NL
Date: 8/6/2001, 7:57 PM


<< Get a catalog from http://www.omega.com for thermocouples.
 You will have to drill the small diameter holes while
 the rotor housings are off the engine. They go right along side
 the leading plug. There is a risk involved in that the rotor housing
 may be more prone to cracking in this area. I would try it
 with less than new housings to begin with. Are the cracks
 that you have seen in the steel liner or just in
 the aluminum part of the rotor housing?

 Paul Lamar >>


The only housing cracks I have seen are on 12A periphery housings and the
crack is through the leading plug hole in the iron liner in the horizontal
plane. The aluminum below the cast iron is no doubt cracked as well, but not
through to the water. I have never seen a side port housing crack. In most
cases, the very serious people that ran the periphery port engines were
turning them 10,700 RPMs for sprint races, and 10,200 for long distance
races. They were processing a bunch of fuel, and making a bunch of heat. I
captured the Omega URL. Thank you.
Lynn E. Hanover.


I think rotor housing deflection is a factor in theses cracks.
That area is in high cyclical compressive stress at high HP levels due 
to rotor housing bending. The high heat gradients in that area does not help. 
The figure eight rotor housing wants to go circular under the 
combustion pressure.  Hollow dowel pins between
rotor housings and end housings would help reduce this
bending and consequent cracking.

Very early NSU spider one rotor engines did the same thing.

Paul Lamar
   
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org