> > > Ed Anderson wrote:
Finn,
Sorry to hear about your drive. Ross's gear boxes are such a
hodge
podge, some seem to give adequate service and operate hundreds of
hours then
others never work correctly from the git-go.
What type symptoms make you suspect the gear box. Noise? Feel?
Oil
temp?
Others of us with the Ross would like to know.
Ed Anderson
Well, Ed. My RV-3's annual is due this month. It was high time to send
the prop
back to Clark to have it finished. I had promised myself to inspect the
re-drive
around 150 hours. I haven't really noticed any symptoms. Still don't
know if that
"tight spot" I noticed the other day was from a stuck apex seal or from
a piece of
junk in the gears.
In the process of replacing the oil pan plug with a magnetic one, I
drained about
1 gallon of oil and fished around it with a magnetic pick-up tool and
didn't catch
any metal.
Finn
Thanks, Finn
That what makes it a little scary, no noticeable symptoms. I would like
to think that you would feel some grittness, catching - or something when
you pull the prop through. Also, no metal in the oil pan, guess it could
have stayed in the PSRU as not much pressure to force it down the drain to
the oil pan (if it can find the drain in the gear box).
Sounds like you either have to get this one fixed or go with Tracy's.
I'm facing the same thing - its not "if", its a case of "When". I just hope
I can get 400+ hours like Tracy's
Ed
There are plenty in gyro's Ed with over a thousand hours. Since
you have the early self aligning type yours might go a long time.
Finn's and Chucks main problem is alignment. If it were merely a
lubrication problem the gear wear would be even. Just keep inspecting
it from time to time. What ID of drain back pipe are you using
these days? You might be able to increased the oil flow
with a larger drain back pipe. Also lube the aluminum alignment
tabs with moly grease.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org