There are several possibilities for incorrect machining and other errors.
The gear on the input shaft could be axially mis aligned. Improbable.
The gear on the input shaft is not concentric. Improbable.
The gear heat treat has been affected by welding. Perhaps.
The bell housing is not centered. Likely.
Get a pieces of 1/4 inch Lexan at Home Depot about 16 inches by 16
inches and drill a very small hole in the center. Remove the input shaft.
Place the bell housing with the output shaft absolutely
vertical using a level as shown in this gif.
Use a string and a plum bob hanging from
the small hole in the Lexan and center the Lexan sheet over the
center of the output shaft on the back of the bell housing.
You may have to machine a temporary plug approximately 2.05 inch
in diameter in a lathe to insert in the planet carrier
to give an exact reference for the output shaft center line.
Clamp the Lexan to the bell housing flange using small
C clamps and mark all the centers of the bell housing bolt
holes with a transfer punch. Measure the distances to the center hole of
all the bolt mounting holes and compare them to Tracy's drawing
shown here.
Send me both input shafts with the gears and I will check them for
alignment, concentricity and gear hardness.
Another possibility is the damper plate is not centered on the
flex plate. Unlikely as there is a pilot bushing in the end
of the e-shaft.
Yet another possibility is the two bell housing faces are not parallel.
Place the bell housing alone on a flat surface and use a long straight
edge on the other face to check for parallelism.
What year and month did each of you buy your Ross boxes?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org