Subject: Ross PSRU - bad!!
From: ACRE NL
Date: 8/7/2001, 6:34 PM


Both Finn's and Chuck's Ross drives did exactly the same thing as
mine in
it's final failure.  Mine just took a bit longer at 650 hours.  I
checked
for machining errors on everything except concentricity of the
inputshaft /
sungear.  Didn't check that because that should have been the
easiest thing
to get right (I know, bad logic).  I don't know for certain what
factor
causes the galling failure but my money would be on improper
lubrication.
Ross attempts to get oil to squirt into the ring gear through holes
in the
bulkhead but this is an iffy method at best.

To repair the Ross input shaft it is nessesary to grind the sun gear
off the
shaft until it is a paper thin shell then peal it off.   Drill hole
in new
sun gear (carbide bit required) for pinning to input shaft, install
gear,
pin, then grind the oil seal area to correct diameter.   World's
messiest
operation but it can be done.  Easier to make it from scratch!

Tracy Crook


Tracy, how did your final failure manifest itself?

How long is the original sun gear? 2 7/8" ? ID ~1 7/16" ?
If so, wouldn't it be possible to press out the 3/8" pin, press off the
sun gear.
Press on the new sun gear. Turn down the gear for the real seal, drill a
new hole
and press in the new pin?

I see a couple of holes in the prop shaft. If they get oil from the
pressure line,
one could drill a hole in the input shaft (front end) and pin holes in
the sun
gear to ensure proper lubrication.

Of course, I don't have the machinery to do any of this. Hm... spend
more money on
this drive, use as is or get one from Tracy?

Finn


Hi Finn,
Like you, I was doing an annual inspection on my drive when I discovered the
galling sun gear and the bad prop shaft thrust bearing.  There were no
obvious symptoms except for a slightly increased end play on the prop shaft
due to the thrust bearing. I did not even consider putting that drive back
in service before having it repaired.  Finding these problems is what
motivated me to complete the design of my own drive.

Sun Gear is 2 7/8" long.  Chris Ross described the repair proceedure I
quoted.  I have not actually done it myself and don't know if the other
proceedure you mentioned would work.  Turning down of the gear needs to be a
grinding operation due to the hardness of the gear.  I never saw the prop
shaft holes you mentioned but I doubt that there is a way to get pressurized
oil to the prop shaft & sun gear.  You need a plain (pressure fed) prop
shaft bearing to do that.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org