Subject: Ross PSRU - bad!!
From: ACRE NL
Date: 8/7/2001, 1:38 PM



Chuck's sun gear looks worse than mine. If he's putting his back in service,
maybe so should I. I'd like to reduce the cost from $20/hour to maybe $10 per
hour - getting another 150 or more hours on it.

So this raises the question: How do gears fail?
Do they fail gracefully -- getting more an more worn/pitted and just
increasing the play, or do they fail more catastrophically - like big flakes
of steel coming off and jamming the gears or gear teeth breaking off?

Finn


Not a good idea Finn. You could ruin your engine bearings too.


How so? We know the engine thrust bearing will go. But that's cheap @  $20. I think
I could live with replacing that every 500 hours or so.

Since it is a common oil supply you risk ruining the engine bearings.


BTW, I just measured the fore-aft play of the prop shaft: 0.015"
Is that acceptable or also cause for concern?

Same goes for a breaking up thrust bearing. .015 is getting up there.

Don't put it in back in service either of you.
The gears will continue to break up. New gears are cheap.
the expensive part is making a new input shaft.

Ok, but do they fail in a way that will cause the gears (and prop) to freeze up? Or
do they fail gradually (gracefully)?

You may start to lose engine oil pressure as the particles contaminate the
engine bearings. Not a good idea to risk this. Just fix the box.

What ever you do don't send the boxes back to Chris. You will never
see them again. You might try buying  new input shafts from him
but don't pay until you get them. Perhaps Chuck can drive down
and pick them up.

Really? I had mine all packed up to go ;)

Seriously, though, that may be an idea. But I doubt it'll be worth it. Until the
lubrication problem is solved they'll just continue to wear out.

I think you also need to address the sun gear alignment issue.


Anybody know what goes on in the prop shaft end of the drive? The oil input hole
goes into a 1/16" hole (in addition to the 5/16" longitudial hole that runs back to
the gears) but doesn't go all the way though into the hole in the prop shaft. I
don't understand how the oil gets to the prop shaft front main bearing and returns
from there. I'd really like to drill that hole in the center of the input shaft,
but wouldn't want to steal oil from the prop shaft bearings.

This is something I could do with the tools I have: drill out and through the 1/16"
input  hole so oil spews into the prop shaft, a hole through the front end of the
input shaft and extend the hole in the sun gear into the center of the input
shaft.  Maybe block existing 5/16" oil gallery. Put it back in service and inspect
every 150 hours?

Finn


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org