Subject: Ross PSRU - bad!!
From: ACRE NL
Date: 8/7/2001, 3:09 PM


Both Finn's and Chuck's Ross drives did exactly the same thing as mine in
it's final failure.  Mine just took a bit longer at 650 hours.  I checked
for machining errors on everything except concentricity of the inputshaft /
sungear.  Didn't check that because that should have been the easiest thing
to get right (I know, bad logic).  I don't know for certain what factor
causes the galling failure but my money would be on improper lubrication.
Ross attempts to get oil to squirt into the ring gear through holes in the
bulkhead but this is an iffy method at best.

To repair the Ross input shaft it is nessesary to grind the sun gear off the
shaft until it is a paper thin shell then peal it off.   Drill hole in new
sun gear (carbide bit required) for pinning to input shaft, install gear,
pin, then grind the oil seal area to correct diameter.   World's messiest
operation but it can be done.  Easier to make it from scratch!

Tracy Crook

Tracy, how did your final failure manifest itself?

How long is the original sun gear? 2 7/8" ? ID ~1 7/16" ?
If so, wouldn't it be possible to press out the 3/8" pin, press off the sun gear.
Press on the new sun gear. Turn down the gear for the real seal, drill a new hole
and press in the new pin?

I see a couple of holes in the prop shaft. If they get oil from the pressure line,
one could drill a hole in the input shaft (front end) and pin holes in the sun
gear to ensure proper lubrication.

Of course, I don't have the machinery to do any of this. Hm... spend more money on
this drive, use as is or get one from Tracy?

Finn

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org