Sun Gear is 2 7/8" long. Chris Ross described the repair proceedure I
quoted. I have not actually done it myself and don't know if the other
proceedure you mentioned would work. Turning down of the gear needs to be a
grinding operation due to the hardness of the gear. I never saw the prop
shaft holes you mentioned but I doubt that there is a way to get pressurized
oil to the prop shaft & sun gear. You need a plain (pressure fed) prop
shaft bearing to do that.
Tracy Crook
Is that because oil would push out past the front seal if I were to pump enough oil
into the hollow prop shaft?
Finn
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org