Subject: Ross PSRU - bad!!
From: ACRE NL
Date: 8/7/2001, 8:44 PM


The new planet carrier is cast iron so it is cast iron on aluminum :-)
Perhaps a steel insert if called for on the old Ross boxes.
Ed if you get a chance please inspect your box for this kind of wear.

Paul Lamar

Ed Anderson wrote:

 Paul,
    I last looked at the inside of my gearbox when installing a second vent.
At that time there were no indications of wear either on the sun gears or
the aluminum teeth of the planetary carrier set in the aluminum slots.  But
then I only have approx 160 hours of run on the gear box.  Right now, I am
still flying to make up for the lost year of down time last year.  I will
probably pull the gear box this fall (after Tracy's fly in during the
annual) unless of course some reason to do it sooner.

Ed Anderson

I would not worry about it Ed. Obviously it is self aligning itself :-)
What may have caused the wear on Ron Gowan's aluminum teeth  Tracy mentioned
could have been caused by a non concentric pilot on the input shaft causing
the planet carrier to move around. Apparently you are just lucky and
got a good Ross gear box when everything was done right.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org