There are several possibilities for incorrect machining and other errors.
The gear on the input shaft could be axially mis aligned. Improbable.
The gear on the input shaft is not concentric. Improbable.
The gear heat treat has been affected by welding. Perhaps.
The bell housing is not centered. Likely.
Get a pieces of 1/4 inch Lexan at Home Depot about 16 inches by 16
inches and drill a very small hole in the center. Remove the input shaft.
Place the bell housing with the output shaft absolutely
vertical using a level as shown in this gif.
Use a string and a plum bob hanging from
the small hole in the Lexan and center the Lexan sheet over the
center of the output shaft on the back of the bell housing.
You may have to machine a temporary plug approximately 2.05 inch
in diameter in a lathe to insert in the planet carrier
to give an exact reference for the output shaft center line.
Clamp the Lexan to the bell housing flange using small
C clamps and mark all the centers of the bell housing bolt
holes with a transfer punch. Measure the distances to the center hole of
all the bolt mounting holes and compare them to Tracy's drawing
shown here.
Send me both input shafts with the gears and I will check them for
alignment, concentricity and gear hardness.
Another possibility is the damper plate is not centered on the
flex plate. Unlikely as there is a pilot bushing in the end
of the e-shaft.
Yet another possibility is the two bell housing faces are not parallel.
Place the bell housing alone on a flat surface and use a long straight
edge on the other face to check for parallelism.
What year and month did each of you buy your Ross boxes?
Paul Lamar
Both Finn's and Chuck's Ross drives did exactly the same thing as mine in
it's final failure. Mine just took a bit longer at 650 hours. I checked
for machining errors on everything except concentricity of the inputshaft /
sungear. Didn't check that because that should have been the easiest thing
to get right (I know, bad logic). I don't know for certain what factor
causes the galling failure but my money would be on improper lubrication.
Ross attempts to get oil to squirt into the ring gear through holes in the
bulkhead but this is an iffy method at best.
To repair the Ross input shaft it is nessesary to grind the sun gear off the
shaft until it is a paper thin shell then peal it off. Drill hole in new
sun gear (carbide bit required) for pinning to input shaft, install gear,
pin, then grind the oil seal area to correct diameter. World's messiest
operation but it can be done. Easier to make it from scratch!
Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com
I think it failed after you epoxied the planet carrier in place :-)
You are probably right about the oiling however.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org