Subject: Oil Temperatures cowl pressures
From: ACRE NL
Date: 8/8/2001, 11:09 AM

Perry Mick wrote:

I didn't have enough static line to plumb both ports of the
ASI, so I ran the static port back into cowl, placed just above
the oil cooler.  I left the pitot port open to the back of the
instrument panel.

With the engine running at 2000 rpm and taxiing out it
read 40 mph of vacuum in the cowl, 0.8 inches of water,
0.03 psi.

Full throttle at start of takeoff roll it went up to 100 mph
vacuum, 5 inches of water, .18 psi.

During climbout at 80 knots and 5100 RPM it was reading
95 mph, 4.4 inches water, 0.16 psi.

Cruising at 4800 RPM, 120 knots, it dropped to 70 mph,
2.4 inches of water, 0.09 psi.

So I'm getting plenty of suction out the back and my cowl
is in a vacuum.

The next step is to plumb the pitot port to the inlet side
of the oil cooler and measure the pressure drop accross
the oil cooler.  Then I will start to seal up the oil cooler
on the inlet side.  I'm a bit sceptical since last time I
did this my oil temps went up!

Others have noted a correlation between oil temp and
water temp.  I don't see this, in my plane or in the car.
In my car I used to measure oil temp in the pan, it was
directly related to RPM and would vary widely.

When I had my coolant temp problems in Palm Springs
the oil temp stayed stable throughout at it's normal
210 degrees, so no correlation there between coolant
temp and oil temp.

What bothers me is my oil temp can easily get to 220
going into the engine during climb if I don't throttle
back below 5000 RPM after the first 1500-2000 feet.
During cruise at 4800-5000 RPM it will run 200-210.
Since it's directly related to RPM, it will probably be
240 or 250 if I were running 6000 RPM.

Did you say there are some "turbulence generators"
inside the oil cooler?  Maybe the '82 (12A) oil cooler
that I'm using doesn't have these, although it has exactly
the same dimensions externally. I use it instead of the
'86 because the port arrangement is better.  I'm going
to remote my oil filter eventually, may look at using
the '86 oil cooler when I replumb for that.

Another interesting thing about the 12A cars:  the starter
went out in my '86 car.  I had a 12A starter laying around
from an '83 RX-7 I used to own.  I knew it would fit since
the transmissions were the same between '83 and '86, so
I installed it in my car.  That starter is bigger and heavier
than the 13B starter, and it kicks that engine over like the
spark plugs were missing!  Apparently they needed a
more powerful starter in the old days to get that cranky
carbureted 12A engine going.

--
Perry J. Mick
Duckt N7XR
http://www.ductedfan.com

Thanks for the cowl pressure  data Perry.
What did you do with the end of the tube measuring the pressure?
If it does not have three small holes in the sides or use 
porous foam you can get errors due to local velocities.
Forgot to mention that yesterday.

Paul Lamar

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org