There are plenty in gyro's Ed with over a thousand hours. Since
you have the early self aligning type yours might go a long time.
Finn's and Chucks main problem is alignment. If it were merely a
lubrication problem the gear wear would be even. Just keep inspecting
it from time to time. What ID of drain back pipe are you using
these days? You might be able to increased the oil flow
with a larger drain back pipe. Also lube the aluminum alignment
tabs with moly grease.
Paul Lamar
Hope you are correct, Paul.
My bottom drain is the stock one in most of the Ross drives using a -6
hose. My new one is also a -6 hose, but vents the oil from the rear top of
the gear box. As you will recall, I had persistent oil leak problem from
the rear seal, once I installed the top vent and vented it to the oil sump I
now have over 10 hours with only a drop or two after shutdown.
I had been using a 0.025 oil restrictor (gave me about 1 pint/minute of
oil into the gear box. But, since I put in the two vents, I now have a
0.040" dia restrictor which has increased the oil flow considerably.
Getting ready to yank the EC2 and send it back to Tracy's for upgrade to
its software, including ignition timing control - be interesting to play
with changing the time to see the effects. Besides, been too hot to enjoy
flying much, so good time to do it.
Also, Paul, I am taking my computer in for an upgrade, so will be off the
list until approx Saturday.
Best Regards
Ed Anderson
OK Ed I will just delete any bounces for a week. Thanks for letting me know.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org