Finn wrote:
When I moved my oil filter I mounted it directly on the front cover. High quality water pipe 90
degree elbow from Home Depot :) into a home made 1/2" plate onto which the stock oil filter
adapter bolts. From the 1/2" plate an 45 degree AN #10 fitting and hose to oil cooler. From
there a short hose to standard engine block input. Home made 1/2" plate on top of engine where
oil filter adapter used to sit. Use this plate for line to PSRU, temp and pressure sensors as
well.
Paul, do we have a picture of Finn's installation?
Why? Because it simplified the plumbing, as well as being cheap. I think I have less than 3' of
oil hose. Let's not get into the fact of hanging the oil cooler under the oil pan so it doesn't
drain when changing oil :)
Is that supposed to be a plus or a minus? It sounds bad to me. :-)
Nothing wrong with measuring oil pan temp. Compare that with temp of oil going into engine and
you know how well the oil cooler works.
Paul Lamar replied:
Good idea Finn on the oil filter. Also good idea on measuring the pan temp AND the temp out of
the cooler. One can never have too much data.
Wrong. It may be true that one can never have too much *knowledge*. Knowledge comes from
information; information from data. But too much data can be a bad thing; it's colloquially
called "information overload" and it might cause you to prang your plane or car or boat...
Russell Kent
Thanks for enlightening me on that Russell. Are you sure? :-)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org