Subject: Ross PSRU sun gear heat treat
From: ACRE NL
Date: 8/8/2001, 11:00 AM


Finn Lassen wrote:

I don't think the sun gear is welded to the shaft. Looks like it's
pressed on and held with a pin through the shaft.

However, I guess the grinding (teeth ground off for more than 1/2 the
length) may have elevated temperature?

If the sun gear was put on by freezing the shaft and heating the gear,
would it now be possible to press it off?

Finn


Good point Finn.

You can press anything off with a big enough press.

If you are going to fix it I would scrap the Ross shaft and use Tracy's
rubber damper and input shaft set up. Tracy uses a stock Ford shaft of
some sort and adapts it to the sun gear. It will be easier on the
box and will idle at 1000 RPM without shutter.

Paul Lamar

"Bass, Jerry" wrote:

Tracy's setup may have a different bell housing dimension.

 Ian machined his gear housing to make the sun gear move farther forward,
which changed the teeth mesh for more sun teeth length onto the planet
gears.

My drainage is two 3/8" tubes back to the pan with a 1/4" tube from the bell
housing to the pan.  I should have plenty of oil inside the drive to flow
through the gears.  The two 3/8 tubes are at about 4:30 and 7:30 by the
clock out of the gearbox, looking aft.

Jerry Bass


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org