Finn Lassen wrote:
I don't think the sun gear is welded to the shaft. Looks like it's
pressed on and held with a pin through the shaft.
However, I guess the grinding (teeth ground off for more than 1/2 the
length) may have elevated temperature?
If the sun gear was put on by freezing the shaft and heating the gear,
would it now be possible to press it off?
Finn
Good point Finn.
You can press anything off with a big enough press.
If you are going to fix it I would scrap the Ross shaft and use Tracy's
rubber damper and input shaft set up. Tracy uses a stock Ford shaft of
some sort and adapts it to the sun gear. It will be easier on the
box and will idle at 1000 RPM without shutter.
Paul Lamar
Don Dunbar wrote:
If it looks like a shrink fit with a heated gear and chilled shaft then the
interference fit will be damaged if pressed off cold, too hot and the metal
will pick up and scour.
The method used to install bearings and other hardened surfaces without
damage is to heat in oil to boiling point with the component in and then
install with out heat loss.
I would use this method to remove as the outer housing as it larger and will
expand more that the shaft. the oil will reduce the damage to the shrink
fit. We should look at hydraulic press fitting for these component with a 8
deg taper. This is the most effective way to reduce shaft sizes and transmit
power.
Regards Don
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org