Subject: Adding AN to radiator
From: ACRE NL
Date: 8/9/2001, 3:20 PM


Jerry Hey wrote:

 My Griffin radiator has conventional inlet and outlet hose receivers.
 I was going to cut these off and replace with AN.  I have changed my
 mind about the cutting off part.  The inlets and outlets have a very
 large base to resist the weight of the hoses and are beautifully
 welded in.   Therefore,  I am going to make a plug that has been
 drilled and tapped for the AN fittings (in my case --16. ) to weld
 into the hose receivers.  Likewise I am just going to weld a cap
 (plate) on top of the filler to close it off.   The overflow (1/4"
 pipe) will receive a plug that can be opened when filling the system
 to make sure no air is trapped in the rad.   It couldn't get much
 easier.   Jerry


I think you are asking for trouble there again. I would use 1 3/8 ID
pipe minimum. -16 is one inch ID so 1 3/8 ID is almost twice the
area. As Power Sport says, water flow is very important and you will
have very long lines compared to the rest of us. Greg Richter
is using -24 which is 1.5 inch ID. Your water pump is going to catch
hell.

Paul Lamar

I probably have this wrong but I was under the impression that Tracy
was using 5/8" water lines. Also, I know of a Buick 215 that is using
two 1/2" lines from the block and a 1" return. I've talked to the
gentleman but I have not seen the installation.  

Jerry don't forget a Buick car engine is only 40 HP average or less
or is it in an aircraft?

I was told
yesterday, that the Formula One cars use rather small water lines
that look to be much less than one inch. Once again, I have not seen
the installations and can find nothing on the internet.  When CART
comes to Laguna Seca I will hang out in the pits.  Maybe I can get a
look when a cowl is pulled, if I can wait that long.  When I talked
to Griffin, they had no problem with 3/4" hoses.  On the other side,

Paul you are recommending lines that are larger than on the stock
13-B  which are 1.25", at least on mine.  

The stock engine is not running hoses with a total length of ten feet.

If the engine when run hard
in racing, such as Lynn's. is using a thermostat, then, I reason, the
lines probably don't need larger area than that provided by  the open
thermostat.   By the way, I could keep the 1.25" hoses if I could get
comfortable with hose clamps.  Earl's make a beautiful, super
flexible water hose with ends set  up for two hose clamps. --Jerry

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org