Sun Gear is 2 7/8" long. Chris Ross described the repair proceedure
I
quoted. I have not actually done it myself and don't know if the
other
proceedure you mentioned would work. Turning down of the gear needs
to be a
grinding operation due to the hardness of the gear. I never saw the
prop
shaft holes you mentioned but I doubt that there is a way to get
pressurized
oil to the prop shaft & sun gear. You need a plain (pressure fed)
prop
shaft bearing to do that.
Tracy Crook
Is that because oil would push out past the front seal if I were to pump
enough oil
into the hollow prop shaft?
Finn
The first question question is, how would you pump the oil into the prop
shaft? After you have accomplished that there are several other challenges
(including the oil seal problem). To make a long story short, I see no way
to do it without a complete redesign of the Ross.
Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com
I would fix the mis alignment first and leave the oiling alone.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org