Scott Speirer wrote:
I would be glad to drive to Phoenix and pick you up, as
long as you don't
mind a 3 hour drive to Safford. I am not transponder
equipped so I can't fly
in to Phoenix.
Chuck Dunlap
OOPS doesn't sound practical. Maybe the 182 will be ready
in a week or two.
Keeps us informed on your plans vis a vis this gear box Chuck.
I guess I have heard enough so I don't have to see it:-)
Paul Lamar
Paul,
If you change your mind and fly in to Phoenix or Safford,
please let me know. I'm in
north Phoenix and would like to rendezvous with you and
Chuck to learn from you
gentlemen in person about the wear inside the 2.17:1 drive.
I would also bring my
2.85:1 and have you guys look at it and offer your opinions.
Scott
If you two guys think this is worth while I can do it.
Do either one of you have a vernier caliber. Maybe Chuck could meet
us at another local Phoenix airport.
Paul Lamar
I could fly in to Falcon Field (Mesa) or Deer Valley DVT or I could drive
to Phoenix Saturday or Sunday. I am not sure yet, but I may be in Phoenix
for a Diamondbacks baseball game Tuesday night. My Ross is back on the
airplane at the moment, I would have to take it off again, but its not hard
to do. I could bring dial calipers, micrometers, etc. I did put the shaft in
a lathe to check run-out, I could not detect any, but maybe you know a
better way to measure it. I do not have v blocks or surface plate. Only
about 5 or 6 teeth had spalling, the rest looked fine. I do have another
Ford sun gear. If the old sun gear can be removed without damage to the
shaft it might be repairable. I am not sure anything can be done to make it
last more than another 160 hours but it is worth a try.
Chuck Dunlap
As I recall your planet carrier is bolted.
Drill out those holes in the Ross bulkhead that bolt the planet
carrier to the Ross aluminum bulkhead. Use castle nuts and cotter pins. This
will free the planet carrier to seek a neutral load point on the sun gear.
I would not fly it with the current sun gear or planet carrier.
Once it starts to go the breakup can accelerate. See if Tracy can help you out
with a new shaft, sun gear and torsional rubber dampener.
What do you say Scott? This weekend my be out for me unless my wife
wants to come along. I'll check with her tomorrow.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org