George Lendich wrote:
Robert Barnard wrote:
George,
Thank you. I tried the link, it gives a 404 (not found).
The die looks like a typical extrusion die, large at one end, narrowing
at
the final/product shape where the material exits. The "pulltruded" rods
are
made from whiskers and resin, as the material is pulled through the die
it
is heated up. The die is hotter nearer the exit, so as the material is
pulled, it becomes more viscous. The pulling tends to orient the
whiskers
and matrix in the direction of the pull. Tension is maintained as the
material cures.
These hollow rods are used in sports equipment like "snow stix" to adjust
torsion in a ski or snowboard. I've wondered how to build a fuselage or
wing out of the stuff.
Rob Barnard
No ! No! Rob - Try again, this rod is designed for aircraft spars,
if i've written it down wrong < www.continuo.com/maske> try
Jim Maske <marske@marion.net>
he also produces bigger rod for push rods.
It's called Graphite Carbon Rod - Marske Aircraft Corp.
975, Loire Valley Dve., Marion, Ohio.
Ph (740)389-3776
Fax (740) 389-2236
Jim is very helpful !!
George (down Under)
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org