Subject: Ross PSRU - bad!! What Symptoms??
From: ACRE NL
Date: 8/10/2001, 8:30 PM


Here is a picture of Tracy's input shaft and damper plate. It would be ideal
if you replaced the Ross parts with something like this. As I recall Tracy
said this shaft was made from stock Ford parts. Tracy will have to adjust
the length and supply a pilot extension to fit the Ross.
If he wanted to of course. I am not trying to force him into anything :-)

If you don't want to spend this much money there is a manual transmission
input shaft somewhere that will fit the same marine damper spring plate
spline that Ross supplies. Try a Chev V8 manual transmission for a Camaro.
As I recall there are only two or three different versions of these splines
world wide. I think they are an SAE standard. Just take your spring plate
to the junkyard and see what it fits.

Paul Lamar


It's been a while since I looked at the Ross "clutch" plate, but I think it's possible
to drill up the 8mm holes in the alu "flywheel" plate to maybe 1"D and add the rubber
isolators and mount the clutch plate via those. In other words, simply use the existing
clutch plate.

Finn

I think you would have to thicken it up so the rubber had something 
to bear against. It should be balanced too.

Paul Lamar

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org