Subject: Ross PSRU - bad!!
From: ACRE NL
Date: 8/10/2001, 8:35 PM


If you two guys think this is worth while I can do it.
Do either one of you have a vernier caliber. Maybe Chuck could meet
us at another local Phoenix airport.

Paul Lamar


 I could fly in to Falcon Field (Mesa) or Deer Valley DVT or I could drive
to Phoenix Saturday or Sunday. I am not sure yet, but I may be in Phoenix
for a Diamondbacks baseball game Tuesday night. My Ross is back on the
airplane at the moment, I would have to take it off again, but its not hard
to do. I could bring dial calipers, micrometers, etc. I did put the shaft in
a lathe to check run-out, I could not detect any, but maybe you know a
better way to measure it. I do not have v blocks or surface plate. Only
about 5 or 6 teeth had spalling, the rest looked fine. I do have another
Ford sun gear. If the old sun gear can be removed without damage to the
shaft it might be repairable. I am not sure anything can be done to make it
last more than another 160 hours but it is worth a try.

Chuck Dunlap

As I recall your planet carrier is bolted.
 Drill out those holes in the Ross bulkhead that bolt the planet
carrier to the Ross aluminum bulkhead. Use castle nuts and cotter pins. This
will free the planet carrier to seek a neutral load point on the sun gear.

I would not fly it with the current sun gear or planet carrier.
Once it starts to go the breakup can accelerate. See if Tracy can help you out
with a new shaft, sun gear  and torsional rubber dampener.

What do you say Scott? This weekend my be out for me unless my wife
wants to come along. I'll check with her tomorrow.

Paul Lamar

Paul, if Chuck flies in to Deer Valley (DVT) or Falcon Field, or one of the other
airports in the Phoenix area, I can be a local taxi service, pick you up from PHX and
drive us out to meet Chuck.  (Your wife is welcome, too, of course.)  I'm pretty free
this weekend.  Just e-mail me or give me a call at (623) 434-5907.  This would just
be a learning experience for me ... I don't think I'm going to have too much to
offer, mechanical-wise on the drive units.  I do have basic tools, including drills,
vices, and also a metric dial caliper, (not a micrometer.)

As far as overnight accomodations, I don't think my "bachelor pad" is up to snuff at
the moment.  Sorry.  I could taxi you to a hotel, if you wanted.

Scott


OK I talked to my wife and next weekend is better for us. We have an aunt
that lives in East Phoenix that we would be staying with overnight. I'll bring
a dial indicator with me and a few other measuring tools.
 
Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org