Subject: Ross PSRU - bad!!
From: ACRE NL
Date: 8/10/2001, 8:40 PM


 I could fly in to Falcon Field (Mesa) or Deer Valley DVT or I could drive
to Phoenix Saturday or Sunday. I am not sure yet, but I may be in Phoenix
for a Diamondbacks baseball game Tuesday night. My Ross is back on the
airplane at the moment, I would have to take it off again, but its not hard
to do. I could bring dial calipers, micrometers, etc. I did put the shaft in
a lathe to check run-out, I could not detect any, but maybe you know a
better way to measure it. I do not have v blocks or surface plate. Only
about 5 or 6 teeth had spalling, the rest looked fine. I do have another
Ford sun gear. If the old sun gear can be removed without damage to the
shaft it might be repairable. I am not sure anything can be done to make it
last more than another 160 hours but it is worth a try.

Chuck Dunlap

Chuck,

Scott Speirer wrote:

I'm confused.  Would you be flying in with your RV which has the drive-in-question,
or with another airplane?

Scott

Chuck has two RV's. Lucky guy.
 
Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org