Could this also be used to control the oil metering pump rate as well (ie
using Richard Sohn's adaptor for 2 cycle oil)? Perhaps Peter Nunn could
address this need? I think the oil metering controlled uses rpm and perhaps
mp to control the meter, but not sure.
Yes and yes if you are using the late pumps with stepping motors.
Scott Speirer wrote:
I, too, would be very interested in being able to control the oil metering pump
stepping motor. In SAE paper 900036, there is a section describing the introduction
of the stepping motor in the oil metering system. The stepping motor is controlled
by a microprocessor and receives the following inputs:
1. water temperature
2. air flow
3. engine rpm
I assume the microprocessor the paper mentions is the engine control unit, not a
separate little chip just for the stepper motor, but, I haven't looked at my stepper
motor assembly very carefully yet to see what all is in there.
The inputs mentioned above are for the stock system. I don't think we should try to
use the same parameters, since we don't have all the data that Mazda has for the
temperature of the apex seals as a function of water temperature and so forth. **
The goal I was thinking of is to have the stock oil system just put out a 1:100 ratio
of oil to gas, just as if oil was premixed into the gas in the gas tank. This would
ensure safe operation of the engine. **
When I have time, I plan on examining the stepper motor on my '91 engine to get its
model number. The next task would be to locate the technical specification for the
motor. I have some friends who are students at Embry Riddle University in Prescott,
AZ who have done projects with basic stepper motor control. They have access to a
wide number of motor specifications and I hope to solicit their help. I'll see what
happens.
Scott
What would be the advantage for a constant speed, constant HP, constant
temp aircraft engine? The drawback of course is something else to fail.
It would be a serious failure as you would have no indication until
the seals failed.
BTW I'll wager many rotary car engines have prematurely failed merely
because the small nylon lines feeding the oil to the apex seals
got brittle with age and broke.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org