Subject: Book of the month turbo controllers
From: ACRE NL
Date: 8/11/2001, 3:38 PM


I, too, would be very interested in being able to control the oil metering pump
stepping motor. In SAE paper 900036, there is a section describing the introduction
of the stepping motor in the oil metering system.  The stepping motor is controlled
by a microprocessor and receives the following inputs:

1. water temperature
2. air flow
3. engine rpm

The inputs mentioned above are for the stock system.  I don't think we should try to
use the same parameters, since we don't have all the data that Mazda has for the
temperature of the apex seals as a function of water temperature and so forth.  **
The goal I was thinking of is to have the stock oil system just put out a 1:100 ratio
of oil to gas, just as if oil was premixed into the gas in the gas tank.  This would
ensure safe operation of the engine. **

What would be the advantage for a constant speed, constant HP, constant
temp aircraft engine? The drawback of course is something else to fail.
It would be a serious failure as you would have no indication until
the seals failed.

I'm not suggesting that the three parameters mentioned above be used as inputs to the
controller, but the two inputs the mechanically-controlled oil metering pumps use: 1) the
throttle position, and 2) the engine rpm, multiplied by a scaling factor.

Scott

Yes but the throttle and engine RPM also remain constant for long periods of
time. About the best you can say is it might save a bit of oil during
taxi. With a car it is a big smog issue.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org