> Should you get some photos of the radiator of the whittman a/c ,
please also

 try to get foto's of engine & install and put them on our group site so some
 of us who are interested can download them. This would be Greatly
 Apprecieated, Thanx.Matt.

Jerry Hey wrote:

I am working on it.  So far I have one picture of just the outside of
the cowl.  The information I posted earlier was all wrong (I was
guessing based on one very bad photo).  The inlet is below the
spinner and the air exits upward through the Rad and then through
louvers in the top cowl.
This design would be especially good for redrives with off-sets.  In
fact, if you were using a chain drive, you could set the amount of
offset to provide room for the rad.  Jerry

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org