I could fly in to Falcon Field (Mesa) or Deer Valley
DVT or I could drive
to Phoenix Saturday or Sunday. I am not sure yet, but I
may be in Phoenix
for a Diamondbacks baseball game Tuesday night. My Ross
is back on the
airplane at the moment, I would have to take it off
again, but its not hard
to do. I could bring dial calipers, micrometers, etc. I
did put the shaft in
a lathe to check run-out, I could not detect any, but
maybe you know a
better way to measure it. I do not have v blocks or
surface plate. Only
about 5 or 6 teeth had spalling, the rest looked fine.
I do have another
Ford sun gear. If the old sun gear can be removed
without damage to the
shaft it might be repairable. I am not sure anything
can be done to make it
last more than another 160 hours but it is worth a try.
Chuck Dunlap
Chuck,
Scott Speirer wrote:
I'm confused. Would you be flying in with your RV which
has the drive-in-question,
or with another airplane?
Scott
Chuck has two RV's. Lucky guy.
Paul Lamar
That's right. I can fly the RV4 with Lycoming power with the parts in the
back seat. Correction - the D-backs game is Monday nite so I can drive the
parts over there Monday afternoon (or earlier)or we could meet Tuesday
morning. Next Saturday is no good but Sunday is OK. I am heading to the
hangar to remove the Ross drive. Let me know if one if of these days could
work.
Chuck Dunlap
How about next Sunday? That is good for me.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org