Chuck wrote:
That's right. I can fly the RV4 with Lycoming power with
the parts in the
back seat. Correction - the D-backs game is Monday nite so
I can drive the
parts over there Monday afternoon (or earlier)or we could
meet Tuesday
morning. Next Saturday is no good but Sunday is OK. I am
heading to the
hangar to remove the Ross drive. Let me know if one if of
these days could
work.
Chuck Dunlap
How about next Sunday? That is good for me.
Paul Lamar
Sounds good to me. Scott can you pick up Paul next Sunday?
In the mean time, Paul, can I try to take the sun gear off the shaft or
would you like to see it in one piece first?
Leave it on the shaft for now. I think it would be cheaper and easier
to just get another shaft and sun gear and mate them up.
The arrow in the picture looks like the parting line between the shaft and
the sun gear. It is surface ground there to provide a good seat for the
thrust bearing race/washer.
Chuck Dunlap
Good picture Chuck. Could you take a picture of the spot where the pilot
bearing for this shaft is in the prop shaft near the ring gear bulkhead?
I am interest in that area as if the ring gear is not concentric
with the prop shaft and this pilot bearing... un symmetrical wear
patterns can occur.
Not only that this pilot bearing operates around 8000 RPM as the
prop shaft rotates opposite to the input shaft. If the bearing goes bad
the same thing can happen. In the 2.85 version this is not the case.
Both input shaft and prop shaft rotate in the same direction and
the RPM of this bearing is way down.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org