Subject: Ross PSRU - bad!!
From: ACRE NL
Date: 8/11/2001, 3:49 PM


Good picture Chuck. Could you take a picture of the spot
where the pilot
bearing for this shaft is in the prop shaft near the ring
gear bulkhead?
I am interest in that area as if the ring gear is not concentric
with the prop shaft and this pilot bearing... un symmetrical wear
patterns can occur.

Not only that this pilot bearing operates around 8000 RPM as the
prop shaft rotates opposite to the input shaft. If the
bearing goes bad
the same thing can happen. In the 2.85 version this is not the case.
Both input shaft and prop shaft rotate in the same direction and
the RPM of this bearing is way down.

Paul Lamar


 Mine looks just like Finn's picture.
The brown circle looks like another parting line between prop shaft and
welded ring gear bulkhead which looks like 3/8" thick. Finn is right, it
would be tough to measure runout with a dial indicator, no room between
outside of ring gear and housing. I stuck feeler gages in there, a .035" gap
and rotated the shaft. I don't know how to be more accurate with a flat
feeler in a curved slot, but there appears to be about one thousandth inch
runout. It doesn't seem like a lot, barely detectable. I suppose it could
change when it comes up to operating temp.
The pilot bearing is a Torrington J1616

Chuck Dunlap


Can you get the bearing out and measure the clearance on the pilot shaft?
Is the bearing in good shape?

Use a small set of round drill shanks Chuck to check the runout.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Chuck-Dunlap-RossRingGear.jpg