Can you get the bearing out and measure the clearance on the
pilot shaft?
Is the bearing in good shape?
Use a small set of round drill shanks Chuck to check the runout.
Paul Lamar
Looks like the only way to get the bearing out is to destroy it. The bearing
looks like new, no slop to the shaft pilot. I measured ring gear runout
again using numbered drill bits. Works much better than feeler gages - why
didn't I think of that? :-) I estimated .002" max near the open end and
.003" near the bulkhead. I don't know what the limits would be for this
part, but my Mazda manual shows .0047" max eccentric shaft runout. I think
runout at the engine side of the shaft is more likely to cause wear on only
one side of the shaft. I checked the E shaft in wooden V-blocks when I built
the engine, runout was well within spec.
Here is a pic of what the sun gear shaft did to the end of the Eccentric
shaft. I had to make a spacer about .100" thick to take out the end play. Do
you suppose having that much end play could have caused the spalling from
axial movement of the shaft? It took 80 hours to do this. My previous engine
which also had 80 hours on it when removed had no sign of wear like this. I
never did check the sun gear shaft end play on the first engine but it must
have been less. The only way I can think of to check sun gear shaft end play
would be to measure end play of the E shaft with the PSRU off, then
repeatedly install and check E shaft end play with bigger and bigger spacers
until the Eshaft end play starts to go away, then back off a few thou. Maybe
Plasti-Gage?
Of course having a rear thrust bearing would make all this unnecessary
because then the gear shaft end play would be set in the PSRU and not depend
on the engine E shaft.
Chuck Dunlap
Looks just like what Tracy reported only his was worse I suspect.
A spacer will remove the slop but the Mazda thrust bearing will
fail eventually anyway.
Well the only thing left is to free up the planet carrier after
a sun gear thrust bearing is installed and try it again. I would
start with a new shaft and sun gear however but that of course
is up to you.
Did you check the bell housing for the holes being in the right
place? If they are off the shaft will be cocked in the planet
carrier.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org