Scott, I rode with Jim Mayfield in his 2 place gyroplane quite a few years
ago. He had a 13B with a Ross 2.85:1 drive and put 2 or 3 thousand hours
on
it during training flights. It performed quite well. He was at the
Goodyear
airport west of Phoenix. I think he may have had a Warp drive prop, it had
3
or 4 blades I don't remember which. This was before I had even considered
a
building a Mazda powered plane.
Chuck Dunlap
Yes, I have heard and read about Jim Mayfield's gyro. I don't know what
diameter
prop he had. Also, I'm not sure what the gross weight of his machine was, and
what
the rotor blade diameter was. I suspect it was smaller than my 1200 lb gross
weight. I may try to contact him and get those figures from him, if he
remembers.
Will also ask him how high he ran his engine. The Warp Drive prop he had
probably
absorbed the 160 HP of the 13B NA, but the 200 HP of the 13BT I'm not sure
about.
I think the Groen Brothers test location is still at Buckeye, but they will be
moving
to the Glendale airport. (Jim is Groen Brothers chief test pilot.) There
were a few
newspaper articles last week publicizing a new plant being built for them
there for
their planned production of the soon-to-be-type-certified Hawk 4 gyroplane.
Chuck, thanks for reminding me about Jim Mayfield's ship. I do plan, however,
to
keep my redrive up for sale.
Scott
Scott,
Jim Mayfield's Gyro was a purpose built trainer
for training pilots. I do not now what its gross wt.
was but it was not small. At Copperstate 1995 Jim was
using a three blade ground adjust Ivoprop. He indicated
at that time it was doing a better job than the previous
Warpdrive. I cannot recall what the diameter of the prop
was.
Kelly Troyer
Dyke Delta/13B Rotary Power
A multi-blade 68 inch prop is slightly less efficient for static thrust
than a 76 inch two blade prop but not so you could notice it.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org