Ian & Irene Beadle wrote:
Yesterday for the first time I went to the airfield in good clothes, and no heap of tools in the wagon, just fuel. Had a great day flying.
Here are some pictures showing the cowling modifications. Note the NACA air inlet to the manifold and side louvres for hot air out.
The air inlets ducts are all trumpet (bell) shaped on two sides with no ducts after the radiators. As you can see the inlets to the water rads. are original size. They have 9" X 10" X 2.5" air conditioner evaporators in parallel. The oil inlet is 9" X 1& 7/8" with RX7 oil cooler.
Anybody any hints on painting for minimal weight? She has been primed and undercoated already.
Ian RV6A Downunder.
beadles@webace.com.au
Looks like they will work fine Ian. Needs a little cosmetic
sanding of course but I think you are on the right track.
What was the air temp when you went flying?
BTW folks take a look at a new Honda Odyssey van.
Honda is really getting their cooling act together as the hood
is sealed with a rubber gasket where it meets the grill to minimize the
back cowl pressure on the radiator. First car in the world that
I have seen that on. The rad is about 5/8 of an inch thick
with two large fans and it goes from wheel well to wheel well.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org