Looks just like what Tracy reported only his was worse I suspect.
A spacer will remove the slop but the Mazda thrust bearing will
fail eventually anyway.
Well the only thing left is to free up the planet carrier after
a sun gear thrust bearing is installed and try it again. I would
start with a new shaft and sun gear however but that of course
is up to you.
Did you check the bell housing for the holes being in the right
place? If they are off the shaft will be cocked in the planet
carrier.
Paul Lamar
No I have not checked the bell housing. What did you have in mind?
Chuck Dunlap
Subject: Ross PSRU - bad!!
Date: Tue, 07 Aug 2001 01:09:19 -0700
From: ACRE NL <rotaryeng@earthlink.net>
snips...
Get a pieces of 1/4 inch Lexan at Home Depot about 16 inches by 16
inches and drill a very small hole in the center. Remove the input shaft.
Place the bell housing with the output shaft absolutely
vertical using a level as shown in this gif.
Use a string and a plum bob hanging from
the small hole in the Lexan and center the Lexan sheet over the
center of the output shaft on the back of the bell housing.
You may have to machine a temporary plug approximately 1 inch
in diameter in a lathe to insert in the out put shaft pilot
to give an exact reference for the output shaft center line.
Clamp the Lexan to the bell housing flange using small
C clamps and mark all the centers of the bell housing bolt
holes with a transfer punch. Measure the distances to the center hole of
all the bolt mounting holes and compare them to Tracy's drawing
shown here.
snips....
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org