Peter Cowan/Lexi Cameron wrote:
So, is it fair to say the Ross 2.85 is a different( and better) product than
the 2.17? Does it need any of the mods that have been discussed for the
2.17?
I'd appreciate input.
Peter.
Yes I suspect it is a better product. It still needs the helical
gear thrust bearing added however.
Paul Lamar
Scott Speirer wrote:
Paul,
I was looking at my 2.85:1 Ross Aero redrive, and couldn't find the plate that is shown in
the pictures you posted earlier in this thread. For my drive, hasn't the helical gear on
the input shaft been thrust-isolated already? I assume this is the helical gear your
talking about.
Scott
That plate and thrust bearing was designed by Jerry Bass and added later.
Also Ian Beadle uses something similar.
Perhaps it has. What is that stuff behind the sun gear? Are those needle
bearings? If so it looks like it already has the required helical gear thrust
bearings. Looks like Chris Ross got the message on this one.
I think you would be making a mistake selling this Scott. It is near perfect
for a 13B rotary powered gyro. Just use more blades on your 68 inch prop.
You will gain a bunch of thrust as you will have 20 to 25 more HP
at 7500 RPM than you could get at 6000 RPM with a 2.17:1 PSRU.
BTW the workmanship on this looks pretty good if there are no run outs.
Also BTW there is no need of my coming over there next weekend
as both you and Chuck have sent fine pictures.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org