Subject: 3B powered lifeboat
From: ACRE NL
Date: 8/15/2001, 10:28 AM


I am in the process of developing a lifeboat design, primarily intended for
 > Coast Guard Auxiliary applications.  My conceptual propulsion system at
this
 > time is a Mazda 13B engine mated to an appropriate transmission (with a
 > hydraulic pump PTO) and water jet drive.  I am currently in need of
exterior
 > engine dimensions, as I need to minimize the overall height of the engine
 > configuration (as well as optimize maintenance access), consequently the
 > "plugs up" configuration may be appropriate for my application.  If
 > possible, please refer me to a source for dimensioned exterior 13B engine
 > drawings.  Any thoughts you may have regarding my intended application
will
 > be greatly appreciated.  Thank-you in advance for your assistance.
 >
 > Sincerely,
 > Gordon Hansen
 > Wakulla Aeromarine
 > 921 Maplewood Avenue
 > Tallahassee, Florida 32303


If this is going to be an auxiliary life boat which is not used frequently,
you might be better off going with a standard marine 2-stroke or diesel (to
suit the application).  The apex seals are notorious for sticking in their
slots if the engine sits for more than a couple of months.  Could be bad if
you needed it to start in a pinch.

Dave Leonard

Maybe not if only two cycle oil is used. I don't think we have enough experience
to say that yet.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org