It is very hard to do. Not doing it will be very$$$$$. If you run a
thermostat, drill a couple of 1/8" holes along the upper edge of the
flange.
Or cut a "V" notch out of it. Otherwise it will not let the air out of
the
engine. The air trapped under the thermostat will not let coolant heat
the
thermostat so it will open. Believe me now for free, or believe me later
for
big bucks.
Lynn E. Hanover.
Very very good description of what is going on in there. Best I have seen.
Thanks Lynn.
Paul Lamar
Thanks, Lynn
I inserted a thermostat twice (RX-7 13B thermostat) and neither time
could I get the thermostat to open and the temps would keep climbing. So
perhaps trapped air kept the hot water from the thermo element.
Ed Anderson
Ed's situation is rather unique as he is running plugs up and the
water inlet and outlet to the block is no longer the
highest point on the engine. So too then is the thermostat.
Just thought I would let you new guys know.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org