Subject: [Fwd: Kis crusier thrust line.]
From: ACRE NL
Date: 8/16/2001, 4:22 PM


Bill Schertz, I talked to Rich about that and he said the dynafocal 
mounts sagged
about an inch at the prop flange. That is why things are the way they
are :-)
Paul Lamar


 I didn't see the original post but if you want your spinner to line
up with the cowl after accumulating some hours, buy the aerobatic
mounts.  They are much stiffer.   Jerry

Bill was bemoaning the fact that the Kis firewall thrust line did not line
up with the Kis cowl. This only applies to Lycoming cantilevered mounts.

Its not a problem with the Questair Venture type bed mount that I am using
Jerry. The engine is supported ahead of the engine CG so there is very little
deflection in the rubber mounts. If you get the thrust line in the middle
of the cowl hole it will stay there.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

rad-under-engine.jpg