"Bass, Jerry" wrote:
Great thoughts. I think the water cooling, i.e.. salt water may play
havoc
on the aluminum, cast iron. If you add a heat exchanger, then you are in
the
same box we are in, with different sizes, flow rates and even neucleate
boiling.
Jerry Bass
Jon Lauter may still be away on holidays or I'm sure he would comment on
this post.
I'm within a few hours of firing up one of his engines that is replacing an
old volvo 110 hp. His system provides a closed cooling system with two heat
exchangers (beautiful copper units that have dozens of tubes around which
the oil or coolant flows while outside water flows thru the tubes).
Because his exhaust manifold is ALUMINUM (water cooled of course) I am very
concerned about knowing of any water flow problems. So, I've installed a
temperature sensor in the exhaust downstream from the water mixing point. If
this goes above 160 it activates an alarm. This was a commercial unit from
Vetus.
The other sensor is my own invention which detects absence of water in one
of the lake water hoses and also sounds an alarm. It is based on current
flow in the water and uses a small circuit and a relay. A buddy actually
came up with the circuit for me.
My center housing has no burp hole but may add one later. Jon did not
suggest it was necessary but Lynn's words give me pause.
Peter.
I need to go for a ride in that Peter :-)
Where are you?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org