Subject: 13B powered lifeboat
From: ACRE NL
Date: 8/16/2001, 9:29 PM


<< > >"Bass, Jerry" wrote:
 > >>
 > >> Great thoughts.  I think the water cooling, i.e.. salt water may play
havoc
 > >> on the aluminum, cast iron. If you add a heat exchanger, then you are
in the
 > >> same box we are in, with different sizes, flow rates and even neucleate
 > >> boiling.
 > >>
 > >> Jerry Bass


 > All the marine IC engines that I am familiar with use a glycol/water
coolant in
 > the block and a sea water/coolant heat exchanger.  The one I have worked
 > on the most had a copper tube and plate heat exchanger with an easily
removable
 > rubber end cap to permit cleaning and inspection.
 >
 > Bill
 > Long EZ builder & pilot
 > BSME, MSME
 > EAA Technical Counselor >>

There are many "raw water cooled" marine engines out there, in fact "fresh
water cooling" (the closed glycol system) is an expensive option on most
gasoline engines. We include it as standard on our products for the reasons
stated previously. We just repowered a boat with a four cylinder OMC engine,
raw water cooled. The corrosion ate through the cylinder, so that salt water
filled the sump.

Jon

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org