Peter Cowan/Lexi Cameron wrote:
Hello Paul,
Your welcome to come for a ride but I'm not at the most convenient location
for you. Nearest major airport is Toronto and I'm a couple of hour drive
from there. I'd bet Jon L could set you up with one as well. ( Toronto would
also get you near Jim Mosur and Neil K.
On another issue, I'm planning to leave the oil injection system intact for
now but disconnect the linkage to the carb, then go 100 to 1 oil mix in the
fuel. Should be in the water on Sunday.
This project has given me some concern about my future rotary in aircraft.
With this engine, most of the work was already done by Rotary Power Marine
yet it has still taken far too many hours to get it operational. All I've
done is rearrange and minor mods to heat exchanger piping, minor motor mount
changes, a couple of brackets and wiring. Guess I'm just slow.
Peter.
I am familiar with that part of Canada. I get up there from time to time.
Are you near North Bay? I was stationed in Ramore near Kirkland Lake
for two years.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org