Scott Speirer wrote:
More info out of the 2001 Turbonetics catalogue ...
There is a page for custom upgrades to stock turbocharged cars. For the
Mazda RX-7,
years 1988-1992, their upgrade is labeled "S V/HT-18". I didn't know
what this
meant, so I called them up.
The HT-18 is the stock turbocharger, and "S V" is short for Super V,
which is the
T04B V-1/V-2. Your stock turbo is required of you as a core. They use
the stock
twin-scroll turbine housing, turbine, turbine shaft, and center section.
The
compressor housing housing and compressor wheel is changed out for a
T04B V-1/V-2
compressor housing and wheel/impeller. The fellow I talked to quoted me
$635 for
this upgrade.
This new hybrid unit will put out up to 18 psi boost. This is too much
boost for my
needs, but all this is interesting because the compressor map for this
compressor is
in their catalogue and on their website. So you can see the airflow
rates through
the stock turbo engine with this compressor. And one would assume the
compressor is
not surging and that as engine rpm increases, the subsequent line that
could be drawn
on the map would travel through areas of acceptable efficiency, (above
68%).
Good work Scott. Thanks. I saw that and was curious about that myself.
Paul Lamar
Talked to Turbonetics today to order a hybrid for the 90T2 - he gave me some
price breakdowns.
'Regular' upgrade - bored out stock housing, 46 trim compressor wheel
'Hi-power' upgrade - new comp housing and wheel (IE T4 or so, up to 60-1).
$550
I needed a new exhaust housing and wheel, so add $100 (normally $150)
I also opted for ceramic coating on the outside of the exhaust housing, add
another $70.
So $744 with labor for a T04B comp wheel, T4 housing, new bearing assembly,
clipped new exhaust wheel, and ceramic coating. Much better than the prices
I got from others for a stock replacement.
Of course, this wheel combo was chosen to maximize boost in the lower engine
speeds, which is not really what you want for an aircraft. He suggested the
60-1 comp with an external wastegate for that. Said the larger wheel will
take quite a while to spool, so it will be making most of it's boost above
6000 RPM... which is where you guys run :)
Mike Harrington
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org