Subject: ARP tension bolts
From: ACRE NL
Date: 8/18/2001, 12:51 AM



The ARP bolts are indeed going to be tested for engine vibration
resonance
(torsional strain) on a 13B. One of the things ARP could not believe is
that Mazda would thread the bolts as far as they did. ARP may neck them
down to tune the resonance but they will not thread them where they
don't
need to be threaded......
Paul,

Any further word on the ARP tension bolts? I remember you talked to
someone
there.

On my list of things to do.

Everybody send email to Alan Nichols ARP <alann@ARPFASTENERS.COM>

And ask him about 13B tension bolts. Maybe a bit of reminding might speed
things up.


Paul Lamar

Paul and group,

Just got Hayes Racing catalog this week and they put heat shrink tubing the
full length of the tension bolts for $36.00 (race engines). I'm going to
send mine out next week. This will cut down on resonance considerably. I
think it was Butch or Bill that mentioned that RTV under heat may expand to
much and cause major pressure inside the bolt cylinder. I don't want a hand
granade in side my motor. That scared me!! :o

Ken Gillanders
BD4 Rotary

RTV has been used for years. Its not going to break those
cast iron or aluminum housings. Put it on in a spiral line.
The advantage of the RTV is a perfect fit. Are yours necked
down?  A bit messy when removing them however.

Heat shrink works of course. Paul Yaw recommends teflon heat shrink
tubing. Call Paul Yaw and see were he gets it. As I recall Paul just 
told me that Mazda racing sells them with heat shrink tubing.

How much does Hayes want for the tension bolts themselves?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org