Subject: 3B powered lifeboat
From: ACRE NL
Date: 8/19/2001, 11:30 AM


We have not had any instances of sticking apex seals in marine
applications.

 > I think it is more a function of the load when in operation than the time
 > that the engine sits. If the engine is only idled or run lightly between
 > shutdowns, then the seals may be more likely to stick. In marine
 > applications, the engine is almost always used at high load, even if it
is
 > used infrequently. Thus, the deposits don't seem to form.
 >
 > Jon Lauter
 > Rotary Power Marine Corporation
 > www.rotarypowermarine.com


 Perry and I noticed the engine was much cleaner when the EGR was disabled.
 I am sure you disable the EGR Jon don't you? Do you use the stock oil
injection
 pump?

 Paul Lamar


Talk to Ed Anderson about stuck apex seals in an engine that has been
sitting.  His story is similar to that of many RX-7 owners who have let the
car sit.  The apex seals in this instance stick because of what I am guessing
is oxidation, not because of the usual carbon gunk build-up.  It apparently
is made worse if an injector is leaking to wash the oil coating off.  Im not
saying that a marine application is prone to sticking - I think a marine
application is almost as practical as an aircraft application.  But a rotary
that sits for months or even years before it is started will probably be more
difficult to start than its reciprocating counter parts.

IMHO,
Dave Leonard

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org