Subject: How to cool your wankel fragment 2
From: ACRE NL
Date: 8/21/2001, 8:22 PM

Second fragment of new EAA article.

OK guys have at it.
Tear it apart.

"This is a bit subtle and concentrated so it will take some 
cogitation and re-reading for this to sink in.

We will define heat flux here as the rate of heat transfer per 
square inch of transfer surface. HP is a force times a velocity, or 
put another way, force times a distance traveled per second. 

Since watts (heat) and HP are interchangeable (746 watts equals one 
HP) if your engine has 20 square inches of combustion chamber  
surface to transmit 100 HP worth of waste heat that is easier to do 
than transferring 200 HP worth of waste heat with 20 square inches.  
Related to this is the HP per cubic inch displacement of the engine. 
The higher the continuous HP per cubic inch the more severe the cooling 
problem. 

Temperature gradients in the metal are also very important. A temperature 
gradient is defined here as a rapid change in temperature from one 
part of a solid to another. High temperature gradients lead to 
cracking as part of the solid wants to expand and this expansion is 
resisted by the cooler parts.

This is the very crux of the situation in getting the heat out of 
the metal and into the coolant when dealing with high continuous  HP 
per cubic inch engines. 

In a typical water cooled automotive type engine the water jacket  
inside the cylinder head is inaccessible. You can not open up the 
head and make modifications and improvements  to the water jacket. 
Fortunately this is not the case with a Mazda wankel engine. The 
rotor housing is a separate part and when the engine is unassembled 
the interior part of the rotor housing water jacket is readily 
accessible for modifications. In fact several modifications  have 
been tried such as grooving the walls of the water jacket to improve 
the heat transfer from the metal to the liquid coolant. We have 
discovered that this is unnecessary if you limit your engine to around 
200 HP for take off and cruise at 175 HP. However this feature may 
come in handy in the future when we get more experience with higher 
HP turbo charged Mazda two and three rotor engines.

Once boiling of the coolant starts it is all over. Things go to hell 
in a hand basket very quickly indeed. This is what I mean by an 
unstable cooling system. Forget all you have learned about car 
overheating. You cannot just quickly reduce power and  pull over to 
the side of the road and stop.  A few experiences like this during 
climb out can be very discouraging indeed. Many people have given up 
on water cooled aircraft engines at this point. It takes an extra 
amount of perseverance and determination to continue. 

Having said that it is best to test your new water cooled airplane 
at low use, uncontrolled airport so you can get it back on the ground 
right now!  Otherwise you may damage your engine.

It is also best to suppress your creative urges and copy some system 
that someone else has used and that  you know works. Later on, after 
you have flown your airplane for awhile, you can do a little creative
experimenting."


Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org