Paul Lamar wrote:
I am working on another article for the EAA
so I need some help from you heat transfer guru's.
Anything incorrect in this fragment?
Anything that could be worded better?
"There is no cooling but air cooling. Ultimately all waste heat
must be dissipated by the air surrounding the aircraft. There
are three main ways of transferring heat. Conduction, convection
and radiation. Conduction takes place within the same solid
while convection happens between a solid and a fluid such as air
or water. Radiation takes place by one object "seeing" another
hotter object. No not nuclear radiation. You can get a sunburn
at the beach no matter how fast the cooling breeze is blowing.
You do not get a sun burn if you are in the shade. This is a
classic example of heat transfer by radiation. We are mainly
concerned with conduction and convection when cooling an engine."
Your definitions of conduction and convection aren't precisely correct.
Conduction is the transfer of heat that occurs as the individual
molecules bump into each other. It occurs in all phases: solid, liquid,
gas, plasma. Because of the large distances between molecules in gases
and plasmas, conduction works poorly in those phases.
Convection is the transfer of heat that occurs as the heat-induced
changes in density cause the fluid (liquid, gas, plasma) to flow in a
gravity environment. Because solids cannot flow, convection cannot occur
within them. Convection only occurs within a homogeneous phase (i.e.
entirely within liquid, gas or plasma).
Radiation is the transfer of heat that occurs when energized ("hot")
molecules expel energy in the form of photons (usually infrared light),
and nearby cooler molecules absorb the photons. It occurs in liquid,
gas, and plasma phases. [It may occur in the solid phase, but at scales
so small and at temperature gradients so high that you'd need a
well-equipped nuclear lab to observe it. Basically you have to pump
energy in faster than the solid can either transfer it via conduction or
melting.]
Heat can also be transferred through phase changes.
Heat is transferred across a phase boundary (solid/liquid, solid/gas,
liquid/gas) only by conduction and radiation.
All of the above should be covered in a comprehensive understanding of
the mechanisms of a water-cooled engine.
What do they call the amount of heat transferred per unit time
through a given area such as a cylinder wall? Is that called "flux"?
"Flux" means flow. In technical discussions, it means the rate of flow
through a surface (perpendicular to it). Heat flux (also "thermal flux")
is measured in Joules/sq.meter/sec. or kilocalories/sq.meter/sec. [both
metric] or BTUs/sq.ft./hr [English].
Russell Kent
And HP per square inch:-)
Thanks Russell. Well put and explained.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org