Subject: Ross gear box
From: ACRE NL
Date: 8/21/2001, 2:16 PM


Rick Girard wrote:

Chuck, I'm not trying to be a smart ass, but could you have
been pushing
on the big side of a taper pin?

Rick Girard


It is possible. I only tried from one direction, but the hole measures .375"
on either side. If it is tapered it is only a couple thousandths at most. I
am not a machinist but taper pins I have seen are obvious. Thanks for the
suggestion though, I hadn't thought very hard about that, just assumed it
was straight.

Chuck Dunlap

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org