Rick Girard wrote:

Chuck, I'm not trying to be a smart ass, but could you have been pushing
on the big side of a taper pin?

Rick Girard

Take your assembly to someone who does wire EDM. It is not actually wire any more. They use carbon rods.

They can desolve the pin down to paper thin without hurting the rest of the assembly.

Lynn E. Hanover

Cost?

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org