<snip>
Thanks Tom.
That leads to another term which is HP per square inch.
I may not put this in the article but that is one reason
aircraft engines are only around .5 HP per cubic inch.
It has to do with the heat flux through the cyl head to the fins.
That is also why a low displacement, high RPM, geared down piston engine
is not all that great of an idea for a heavy duty engine.
Especially sea level turbo or super charged.
I am still thinking about the implications this has on the wankel engine.
One side of the rotor housing catches hell heat wise as it never gets
much of a chance to cool off. We are still in our infancy on knowledge
on this subject. For example how much continuous HP can we really get
for how long without warping or cracking the rotor housings. We sorely
need those thermocouples down near the combustion chamber so we can start
gathering data on this subject.
Jim Mederer Racing Beat is working on this by using an extra water
inlet for the block. The lower of these two water outlets from the
custom direct drive water pump goes straight ahead into the block
on Jim's 900 HP turbo three rotor.
Paul Lamar
Hey Paul,
Why aren't these guys using their own aluminum end housings? What is the
scoop on the aluminum end housings anyway. They cost too much for me to get
interested, but they sure would help in the weight department. BTHW, I
promise that I will put TC's near the spark plug when I finaly get a chance
to put my engine together, although since I have a house to work on for the
next six months I wouldn't hold my breath.
Monty
Well Jim Mederer is charging like $1200 each for aluminum end housings.
They are not easy to make as the wear coating probably has to be
applied with what is called a detonation gun to be absolutely
reliable. A detonation gun shoots carbide particles at the wear
surface and then it must be ground and or lapped.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org