There are no advantages since the tall distributor was done away with
15 years ago. In fact there are many disadvantages. The engine was designed
to be run upright.
Paul Lamar
First of all, Mr Lamar dosn't like people saying "plugs up" in his chat room. If you must talk like that, go outside. There are some advantages to running the engine in that "funny" position. The engine is a bit taller than it is wide and puting it in the wrong way makes it a bit lower. So, the center of the crank and the PSRU are close or closer to the thrust center >line in the plans.
Not true Lynn. You are forgetting the length of the spark plugs.
I got a rotor housing right here. It is 7.5 inches from center line to the
tips of the plugs. From center line to the top of the rotor housing
it is only 6.5 inches. The rest of the stuff above that can be cut off.
The sole justification was the height of the old distributor. PL
The intake system can be long for good tuning without crossing the top of the engine.
The water pump is then lower in the coolant system and less likely to cavitate of loose prime if there is air in the system.
The water pump may be lower but the water inlet and outlet from the block is
no longer the highest spot on the engine as Mazda intended so vapor (notice
I did not say air) bubbles can form and be trapped in the water jacket.
This is probably the most serious problem of all. PL
And last, the exhaust goes straight down without a 90 degree turn.
The down side is: using the stock oil pump can lead to a loss of prime (and oil pressure). More likely if the pickup tube diameter is increased. The engine mount is more complex. No longer a simple bed mount. Finding a location for the oil cooler and coolant radiators is a bigger problem because the intake and exhaust systems are on the bottom, taking up space. Oil drainback to the sump is less efficient at the rear main as the seal runs 1/2 submerged in oil. And you have to make a funny oil pan for you funny engine. It has been done, but it is a bunch more work.
Centrifugal force is a good substitute for gravety. You can generate centrifugal force but you get gravety for free. Any aerobatics that are limited to not less than one G force are fine with no special oiling system.
I have a dry sump system on my race car, and would not put it on an airplane because of wright, complexity and cost. The pump was $1,400.00. You would need in addition, an inverted fuel and oiling system.
Lynn E. Hanover
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org