Subject: Oil Cooler Duct Pressure Measurement
From: ACRE NL
Date: 8/23/2001, 4:30 PM

Perry Mick wrote:

Paul:

Back from vacation.  Flew this morning a short flight.  With the pitot
line in the inlet side and the static line in the cowl near the oil
cooler
exit, I get negative pressure readings.  There is a lot of suction out
the back so air is flowing through the oil cooler, but it's not from
pressure from the front during flight.  The 0 mph indication on the
ASI is about 260 mph going around the dial. It would read -10
to -20 mph on the ground and -30 (230 mph) in the air.  You have
some pictures of my new oil cooler duct.  It is mostly sealed up
now.

How do I get pressure in the front?  Maybe the big suction in
the back overrides any possible pressure in the front?  Make
the inlet smaller?  Make the exit smaller?

--
Perry J. Mick
Duckt N7XR
http://www.ductedfan.com

Welcome home Perry. Hope you had a nice vacation.

Sounds like you are going supersonic and there is a negative pressure
wave under the strake in the arm pit. The Long EZ has a twisted
wing so perhaps you are going so fast the strakes are operating
at a negative angle of attack while the tips are at zero angle
of attack :-)

Methinks there is something wrong with your pressure measurements. 
Did you use a little tube with three equally spaced holes in the sides 
as a pressure sensor? I would have a lot more confidence in the data if 
you measured the pressure both front and back of the rad simultaneously 
on the same flight with the same atmospheric conditions. In other words 
a water manometer mounted side ways in the back seat with a camera record.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

New-oil-cooler-duct.jpg